Fcr

[kfxguy]

Originally Posted by 007kfx

That needle made that kind of difference????? I got a bog that will thro you over the bars...Ive only had the bike out once since the rebuild but it did do some tuning ...plug looks like chocolate milk...I used wire in stead of o-ring...should do the same thing...I think?

Did you set the squirt timing correctly? The squirt should just miss the slide.....very very important to get this correct.

[007kfx]

I don't think its quiet that close but....ill make it that close,soon as I get home tonight......how much fuel should be squirted....alot or a little??? I am not to sure on what the jet size is for it ill figure it out the repost results....thanks KFXGUY

[kfxguy]

Originally Posted by 007kfx

I don't think its quiet that close but....ill make it that close,soon as I get home tonight......how much fuel should be squirted....alot or a little??? I am not to sure on what the jet size is for it ill figure it out the repost results....thanks KFXGUY

Take the bowl off and see if there is a small jet in the bottom of the bowl. Some fcr's don't have it. If it has a jet , remove the jet and solder it closed. Then like I said above, when you crack the throttle slowly, the fuel squired should just miss the slide. You'll likely have ti turn the screw flush with the linkage to get it right.

[TJHurst]

How can you tell what kind of carb is on your bike when i bought mine he had replaced it Im guessing since he has removed stock choke and the carb had a pull choke on it