Suzuki Central Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
Is the ball joint shaft size on the lower control arm supposed to be smaller on the 05 vs the 04? I just picked up an 04 with a bent control arm and bought a stock 05 replacement arm as a temp solution and the ball joint shaft is smaller. Normal?

Any ideas where I can get one stock for cheap by friday?

Thanks
 

·
Registered
Joined
·
2,286 Posts
yes, i believe that was the year they changed them. youll need to get an 03/04 arm or change out your spindles
 

·
::3 Pump Chump!::
Joined
·
3,047 Posts

·
Registered
Joined
·
202 Posts
So if you ran it like that it's not secure, and always has "wiggle" room?
 

·
Premium Member
Joined
·
5,886 Posts
Definitely not a good idea to run it with the smaller joint.
 

·
Registered
Joined
·
33 Posts
Discussion Starter · #7 ·
Yes there is wiggle room and I wouldn't run it like this. I'll run the bent one for the weekend if I have to but I'm going to try to find one by thursday.

Thanks for the help
 
1 - 7 of 7 Posts
Top