i would say they are better than stock. Yes you can still use your stock controls because it tapers back down to 7/8 at the controls. Almost all bends except for ProTaper Raptor bend is lower than stock.
1 - 6 of 6 Posts
Personally I just swapped to some 1 1/8 bars from stock, other then adding an anti vibe clamp I don't think it's much of a difference. I also put a +2 taller stem on so they are basically the same height but about 2in wider and a bit less swept back. The fatter bars made putting all my handlebar mounted stuff a bit more awkward but it all fit in the end.
They probably will hold up in a rollover better but I did quite like the impact damping of the stock flexible steel bars. These are Turner RC/RM High Bend from Motorsport, Alba +2 stem and anti vibe clamp.
![Tire Wheel Car Vehicle Motor vehicle]()
They probably will hold up in a rollover better but I did quite like the impact damping of the stock flexible steel bars. These are Turner RC/RM High Bend from Motorsport, Alba +2 stem and anti vibe clamp.
1 - 6 of 6 Posts
