Suzuki Central Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
209 Posts
Discussion Starter #1
so i went riding last weak , and when i start to ride,the clutch slip from first multiple times until like 10 tries and then he catch ,later on i drive it, and some times while driving, it hit the rev limiter at 2th/3rd/4th gear,
i think this issue only came after clutch replacment ,(ebay non-quality one).
1st-i know this question were asket 1000 times , but which brand to get?
(Barnett is too expensive for me , im just trail riding atm...)
2th-i remember that i only had 1 washer(10 or 11 at the pic) when i did the clutch replacment , could that impact something?(iwill defintly get it for next time replacment)
 

Attachments

·
Super Moderator
Joined
·
4,502 Posts
What year? The clutches changed late in 2004. Did you soak the friction plates in oil overnight before installing? Adjusted properly?
 

·
Registered
Joined
·
209 Posts
Discussion Starter #3
2007 dvx, i did soak it overnight before, im not sure about the adjusting properly....
 

·
Registered
Joined
·
209 Posts
Discussion Starter #4

·
Super Moderator
Joined
·
4,502 Posts
No idea what brand that clutch is, but the small ring usually gets stuck to the clutch basket.
The adjuster is a few inches away from the arm, mounted to the engine case. There should be a little slack in the cable between the adjuster and clutch arm. Then you can adjust the lever where you like it. Too much or not enough play at the base will burn em up fast.
 
  • Like
Reactions: piki

·
Super Moderator
Joined
·
4,502 Posts
I’ve had EBC, they work fine.
 
  • Like
Reactions: piki
1 - 7 of 7 Posts
Top