[squigy123]

I read through the manual and it does not give a torque spec for the clutch spring bolts does anyone know the proper procedure for tightening these down?

 

[camaro1976]

the 6 on the outside of the basket? there is no torque, just snug them down

 

[z400brian]

Dont go too tight, I striped one out. Believe me, its not fun

 

[squigy123]

ok thanks for the fast replies.

I just wanted to make sure

 

[Idk]

Dont go too tight, I striped one out. Believe me, its not fun

Where did you find a replacement screw? I cant find them anywhere.

 

[piki]

its an m6 bolt bro

 

[piki]

https://www.partzilla.com/catalog/suzuki/atv/2006/quadsport-lt-z400/clutch-model-k5-k6-k7

 

[piki]

part num11

 

[Idk]

its an m6 bolt bro

Ok thanks i was looking for replacements online but none of the kits had screws with them so I figured i would ask. Also i am refilled it with oil but its only going into the main box none of it is going into the engine how do i prime the engine? I know cranking it over will fill it but i dont want to crank it while there is no oil in the engine.

 

[piki]

U fill it from the oil tank (black in the front of the quad , 2.2 Lit will flow to the engine with no problem...

 

[jetmech25]

After a rebuild, I put about half a quart in the inspection hole where you line up the T for TDC to be sure the pump gets oil immediately, then pour the other 1.7 or so quarts in the tank. Supposedly not necessary, but makes me feel better.