Suzuki Central Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
254 Posts
Discussion Starter #1
i just installed my dynojet kit and just installed the main jet (155)..i didnt mess with the pilot , air screw, or needle....i just swaped the main jet and that was it.....it seems to run fine. should i put the needle in or just leave good enough alone??? and how hard is it to replce the needle??
thanks
 

·
Registered
Joined
·
794 Posts
U shouldn't need to mess w/ the needle for just an exhuast.


Later
 

·
Registered
Joined
·
773 Posts
i replaced the needle also, i figured since i had it i might as well put it in. its not very hard to replace, the instructions are pretty well written. i dont think it changes much, just able to be adjusted if necessary.
 
1 - 3 of 3 Posts
Top