Suzuki Central Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter · #1 ·
I have a hindle slip-on. It's probably the same thing than a hmf. I have a uni air filter too. But i don't lid my air box. i use the stock jet. But I need some help because some of you are all re-jetted. Thanks for your help.



Yellow z-400
nerf bar, bumper et skid plate a/c
Hindle slip-on,
uni Filter
pro design kill switch


It's all about the "Z"
 

·
Registered
Joined
·
1,739 Posts
If you are not useing a lid. you need to rejet. I use a 165 with my HMF.
 

·
Registered
Joined
·
127 Posts
At Sea level up to 2000 ft above..
I would say try a
155 main
25 pilot
4th clip down from top if using aftermarket needle
1 or 2 washers under the stock needle if still using the stock needle
My suggestion here is to get a jet kit from alba with a 155 main and 160
for like $35 shipped.
2.75 - 3.0 turns out on the air/fuel screw..

This setup should get you really close..
Try this and check your plug
I have a slip on T4 with the lid drilled out and i'm really close to these settings and it just really rips.. My plug looks great..
 
1 - 3 of 3 Posts
Top