Suzuki Central Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Do you have to upgrade cams after installing a big bore kit, I have a problem getting mine to start up, after new timing chain,valves, stock cams lifter buckets and new shims and new top end... it spins over but stops on compression stroke, until you pull the plug out. THANKS
 

·
Registered
Joined
·
337 Posts
Which valves? u sure timing is correct ? , u press the starter and the motor stop spinning at TDC ?
doesnt make sense , unless u didnt assemble it correctly (timing marks?) hence the starter stoping...
 

·
Super Moderator
Joined
·
3,610 Posts
are the cams in the 10 and 2 oclock position at TDC? does it turn over by hand at the crankshaft?
 

·
Super Moderator
Joined
·
4,878 Posts
Weak battery?
 

·
Super Moderator
Joined
·
4,878 Posts
Not at all. Should fire right up.
 

·
Super Moderator
Joined
·
3,610 Posts
Are you using the right plug?
 
1 - 9 of 9 Posts
Top