Suzuki Central Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I got this quad with no spark that has had stator/ckp, coil, spark plug, and ignition replaced. Battery gets over 12v. After testing peak voltage of ckp to find greater than 6v, good primary and secondary coil resistance specs, 12v going into the cdi from the orange wire, spec resistance from stator and ckp, I ordered an ecu to fix my problem. Still no spark. Ordered a wiring harness, still no spark. I am a little concerned with my tip over sensor as the one so I have is not original, and does not say “upper/lower.” Will the tip over sensor cut spark? I’d like to test stator output voltage, but every test I’ve found is when the motor is running. I’m just looking for more tests to run so I can find the issue. Any help would be greatly appreciated.
 
1 - 1 of 1 Posts
Top