Suzuki Central Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
94 Posts
Discussion Starter · #1 ·
Has anyone got 7/8" renthal bars mounted on their Z yet? I emailed Renthal and they said that the 400EX bend is closest to stock but I'm thinkin' on trying the ATV race bend. Do they fit over that plastic lights housing or do you have relocate your lights and key?
 

·
Registered
Joined
·
632 Posts
I tried to put the 400EX handlebars on my Z, and it didn't work. The cross pad sits tight on the plastic handle cover, but if you relocate your LEDs to the Front Fender and either use a LT250R Key Housing or put the Key in the Front Fender it will work. The headlight/on-off/start/choke switch is a real pain to take off because you must remove your grip to slide off the bars.

I will hopefully have my switched replaced with a YZ250 Kill switch to start my quad only. The lights are gone, and I don't need an off switch because it has a key for that.
 

·
Registered
Joined
·
94 Posts
Discussion Starter · #4 ·
Thanks ZRacer, that saves me the hassle of trying them on. I think I'm just going to get the trailtech clamp so I don't have the problem of relocating all the bells and whistles.
 

·
Registered
Joined
·
201 Posts
which trailtech clamp do you use. i was lookin at their site and didnt find one, or just over looked it. could i maybe get a link too please?
 

·
Registered
Joined
·
705 Posts
I put the Renthal handlebars 7/8 on my ATV. I just took the crossbar right off of the handlebars.
 

·
Registered
Joined
·
13 Posts
dont think will work without custom made ajustments
 

·
Registered
Joined
·
705 Posts

·
Registered
Joined
·
1,102 Posts
Here are my Renthols with a dash panel I copied from ROX. These are a Banshee bend. I like them alot. Alittle taller and wider but still able to use the stock controls.

z



 

·
Registered
Joined
·
747 Posts
i like that.. the lights and the key up in front , nice
 

·
Registered
Joined
·
40 Posts
Thanks man just one way to do it..
 
1 - 12 of 12 Posts
Top