Suzuki Central Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Working on my brothers king quad 300. Problem .... won't start.. went thru standard checks. Battery, relay, neutral switch, starter. Found Defective starter. Armature burnt out. Installed new.. now starter clicks but does not turn engine. Tried pulling recoil starter and it does not pull, even with compression release open. Expect starter burnt out because engine locked up. Question is... what to check next? Remove recoil starter? Can I manually move flywheel then? Need advice
 

·
Administrator
Joined
·
3,882 Posts
I think you are correct in thinking it may be seized. Mine is back home, and i can't remember if there is an access hole to get a socket directly on the left side crankshaft or not. If so, that is the way to try to turn it over. They were a hard pulling thing with the recoil too, by the way..
 

·
Premium Member
Joined
·
4,891 Posts
is that a belt drive ?
 

·
Administrator
Joined
·
3,882 Posts
No..
 

·
Super Moderator
Joined
·
4,994 Posts
Can't push it in gear?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top