[DadsZ400]

OK everybody that has put on a pipe and a [email protected] filter were did you end up at on jetting, as I am getting ready to do this and would like to know were to start at. Also what is your elevation.
Going to put atleast 6-1 inch holes in the lid and I am not sure if I will be removing the snorkel and will install a HMF slip on.

Thanks,
DadsZ400

 

[Zero Z400]

It depends if ur taking the airbox, snorkel and stuff off. It also helps to know what pipe ur getting.


Later

 

[Barely Legal]

I went with a 152.5 when removing the lid, snorlke, using the HMF and K&N at seal level.

 

[Sand Lovin Z400]

they were out of the 152.5 at my dealer so im gonna try a 147.5. i dont have my lid completly off, i have the uni vents in there, but my snorkel is off and i have some foam from a old air filter glued in front of it. ill show you guys some pics late, its pretty trick. i didnt want sand getting in there since its right in front.

gonna test it out tomorrow.