Suzuki Central Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
363 Posts
Discussion Starter · #1 · (Edited)
I am looking on the webcams website and I like the 293/536 grind. It says that a high compression piston is required however. Will I be able to run this effeciently with just a DRZ-e Base gasket? I would rather not go the high compression piston route at this time.
 

·
Registered
Joined
·
363 Posts
Discussion Starter · #3 ·
Also.... Well I half to reget my 4 whealer if I bye a new camshapht? I dunt now mush abowt carberaters but I wunt 2 go fastur.
 

·
Premium Member
Joined
·
5,886 Posts
Also.... Well I half to reget my 4 whealer if I bye a new camshapht? I dunt now mush abowt carberaters but I wunt 2 go fastur.
LOL, if you can't beat em' join em' right?! ;)
 

·
Registered
Joined
·
363 Posts
Discussion Starter · #6 ·

·
Premium Member
Joined
·
5,886 Posts
 

·
Registered
Joined
·
363 Posts
Discussion Starter · #10 ·
I changed my mind, I think I would be better off with the 288/540 grind. Go big or go home right? I only hope I dont loose too much bottom end with only being at 12.2-1 and still being on stock bore.
 

·
Registered
Joined
·
363 Posts
Discussion Starter · #11 ·
What I really want is some OSHC's......
 
1 - 11 of 11 Posts
Top